|
|
|
|
 The
Shell
The SBS Flight
Case is made of fiberglass with a Gelcoat exterior coating. The
white exterior reduces heat build up inside the case, in the event
that it is subjected to prolonged period of direct sun light.
Our case was designed to accommodate a 3/4 size base with a padded
bag and an extension.
PADDING
The back padding is
made from one-inch thick dense foam and held in place with VELCRO.
This makes it possible to remove the padding if your soft bag is to
thick and extra room is required. Two four-inch thick foam blocks
positioned at the base of the case support your instrument
when in the upright position. Included are eight large two
inches thick dense foam pads which can be positioned to fill the
spaces between bass and case walls.
INTERNAL STRAPS
The straps are made from 1½ in. wide nylon webbing with snap
buckles and are positioned in areas that put the least amount of
stress on the instrument. One in the area of the neck block, the
other at the lower end
of the bass.
|
 |
BUILT
IN WHEELS
The wheels are recessed into the case,
eliminating
the need to remove the wheels before shipping.
Durable,
chemical resistant, rubber ball bearing wheels ride
on a
3/8th inch axle. Wheels are easily replaced should they
ever wear out. |
|
LATCHES
These butterfly spring loaded latches
create a very tight secure closure. Simple to operate, these latches pull the lid of the case
tightly against the body. There are six latch in all
ensuring that the case will hold together under abusive
handling. |
|
|
|
GUARD RAILS
Vulnerable areas have been
protected with WHM, the
same material used for kitchen cutting
boards. This material is long lasting and can withstand
constant abuse.
|
|
|
HANDLES
Five zinc plated, spring-loaded handles
are located at
the top of the
case, bottom, sides and shoulder for convenient handling, and
are recessed into the case to prevent breakage.
Return
to top
Case
Dimensions and Weight
Contact
|
|
|
